Enter a device for high voltage equipment testing can not hurt

Enter a device for high voltage equipment testing can not hurt, since the test is successful. Attention to the following steps to ensure the safety of all technical and to ensure circles.

For high voltage test?

The main reason that the application of this technique is that each part of the circuit isolated from the rest. With small defects in a short-circuit test is not normal, but over time can lead to catastrophic failure of the equipment. And it can be a small cut in the insulation and corrosion of the connectors, improperly or drive from many other sources of short-circuiting problems.

This test is also called a hypothesis test (high capacity) differs from the proof of continuity of most technicians are familiar with. Ensures continuity test current flows easily, so I went along. High test voltage controls the flow of current is not that I do not want it. HV paid outside the normal limits operation to "leak" electricity can be easily found.

As security test

Test equipment is not the capacity to handle High Voltages stress test you. The reason is turning carefully so that it does not happen to fall in voltage sensitive components are tested. Remember that this problem is not the voltage, current will flow when there is no voltage drop.

Should be carefully studied and mental circle invaded networks. And you can see two or more points connected by wires. If the network is to be tested, and any cable, the voltage can be applied safely. If the network components, such as resistors, capacitors, the voltage applied to each point of the network, so that the tension on both sides of each of the components is the same. While both parties in the higher voltage, not the will of a chain component can be damaged.

Use quality test equipment

Once the damage potential high voltage or damage tolerance testing of the technical team, the tags are used in high quality. Stress can cause a current flow incorrectly at the wrong time, and the destruction of components.

You should be aware of the technical characteristics of the test equipment. Not all models work the same way, It does not work model and the other not, even if they are made by the same company. Technicians must be exercised in unwanted equipment until you have mastered the technique. So, if there are no errors damaged expensive equipment.

Once the technical performance is a High Voltage Test several times, is routine. The circuit can be tested quickly and safely, and safety wiring and equipment.